Dermal Fillers – We Use Cannulas

As our bodies age, our skin also ages and begins to show changes that may be undesirable.

The fat and collagen underlying our skin begins to diminish due to the natural aging process. Therefore, our skin starts to sag and develop wrinkles.

At Edans Med Spa we correct this condition by using dermal fillers. The dermal fillers can fill those deflated areas. Dermal fillers are a minimally invasive procedure with little or no recovery time, and cost a lot less then surgery and yield virtually no risk.

Dermal fillers have become a very trendy way to address the aging process.Dermal fillers can be injected into areas with fine lines and wrinkles. Most of the problem areas include the nasal labial folds(parenthesis), Marinate lines, in between the brow, bridge of the nose.


Read More About Juvederm
 mouth, jaw line and cheeks. Other areas that can be enhanced by dermal fillers include the lips, and under the eye which can look fuller and younger after an injection. Scarring from injury to the face or acne can also be corrected with dermal fillers. Edans Offers Treatment with Juvederm Ultra® Radiesse® & Restylane®

WE ARE USING CANNULAS INSTEAD OF NEEDLES AT EDANS MED SPABlunt, Flexible, Dermasculpt does not cut through blood vessels & nerves, making it safer & more confortable for the patient. DermaSculpt is the original Microcannula revolutionizing the way doctors are performing facial Filler Injections!

  • Blunt-tip microcannula

    Blunt-tip

  • Blunt-tip microcannula

    Flexible

  • Blunt-tip microcannula

    No pain

  • Blunt-tip microcannula

    No bruise

Thanks to its Blunt tip (Not sharp) and its flexibility, doctors literally slide the DermaSculpt Microcannula under the patient’s skin so that the filler can be applied with practically no pain or bruising (hematomas) for the patient. With no local anesthesia required, it is truly a revolution in the field because patients will now be at ease with injections!

Composition of the DermaSculpt® Microcannula

Microcannula for fillers injectionDermasculpt is #1 in USA & Internationally.  It is the original Microcannula revolutionizing the way doctors are performing facial Filler Injections!

  • Dermasculpt is made of the same stainless steel as regular sharp needles, polished with a specific industrial process (Polyglass).
  • The end of the microcannula is blunt with a small lateral port allowing for the product to be dispensed into the skin.
  • The length/thickness ratio of the stainless tube is of utmost importance to guarantee the best flexibility and resistance of the needles.
  • The internal diameter and the length of the stainless tube are specifically designed to adapt to the viscosity of the different types of fillers; they determine the filler flow through the needle.
  • Thanks to the quality of the stainless tube, the DermaSculpt® microcannula optimally slides into the skin and allows for an atraumatic penetration through the dermis and Sub-Q layer.

The length of Cannula has a direct impact on product flow

The resistance is proportionate to the length of the cannula: The longer the cannula, the stronger the Frictional Resistance

Inner Diameter VS Gauge

  • The gauge is the outside diameter. The inner-diameter can vary within the same gauge.
  • Most companies will say that a larger inner-diameter allows for better flow of the product. Unfortunately it also affects the flexibility and the strength of the cannula.
  • DermaSculpt is the perfect balance between ultimate product flow, strength & Flexibility

Main advantages of the Skin Sculpting Technique

  • Much safer than using a classical sharp needle because DermaSculpt® does not cut through vessels and tissues but rather navigates smoothly through the dermis and Sub-Q layer (depending on thickness and flexibility of microcannula used)
  • The blunt end and flexibility of the microcannula allow for virtually painless and non-traumatic procedure.
  • Through the fanning technique and thanks to the length of the microcannula, very few entry points are needed in order to cover the entire face.
  • There are also strong reasons to believe that the mechanical action of the DermaSculpt® microcannula on the fibroblasts generates new collagen into the skin.
  • Through the fanning technique and thanks to the length of the microcannula, very few entry points are needed in order to cover the entire face.

Edans Med Spa offers Dermal Fillers in San Antonio.  Please feel free to give us a call to schedule and appointment or click below to schedule an appointment online

 

Schedule an Appointment